General Motors - Leather Fresh Dye Kit

This repair kit is ideal for repairing scratches, abrasions or slight fading on leather furniture or leather car seats.

Contents

• 1 x Leather Cleaner, 200 ml
  
• 1 x Sponge for cleaning
  
• 1 x Leather Cleaning Brush
  
• 1 x Degreaser, 150 ml
  
• 1 x Leather Sanding Pad
  
• 1 x Leather Fresh Dye, 150 ml
  
• 1 x Sponge for applying fresh dye
  
• 1 x Protective Glove
  
• 1 x Leather Protector, 150 ml
  
• 1 x Polishing Cloth
  
• 1 x Instruction flyer
  
  

Application

First, clean the leather thoroughly before refreshing the colour or the application of care products with our COLOURLOCK Mild Leather Cleaner. Cleaning prior to treatment prevents dirt sticking on the leather's surface during colour or care. The Leather Cleaner is provided in a foam dispenser bottle. Foams clean the leather more efficiently than liquid agents, the consumption is considerably smaller, and the leather does not become wet, which could otherwise lead to hardening after drying.

The Leather Cleaner gently cleans all kinds of nappa leather. Apply some foam on the Cleaning Sponge and proceed with cleaning the leather. Remove dirty foam with a slightly moist cloth. Our COLOURLOCK Leather Cleaning Brush will remove soiling from the depths of the grain (for best results, use a circular motion in all directions). You can also use the cleaning sponge contained in this kit. After cleaning or, in the case of recently treated or oily leather, degrease it using COLOURLOCK Leather Degreaser. Smooth out areas that have become rough due to wear with the COLOURLOCK sanding pad before dying. Then remove the sanding dust with a cloth moistened with degreaser.

Once the surface has been prepared, apply COLOURLOCK Leather Fresh to revitalise the leather's original colour on scratches, abrasions or slight fading (which are often found in vehicle seat side bolsters and furniture sitting areas). Apply the colour on a dried Surface only. Use a sponge to apply the colour evenly on the respective surfaces, working from seam to seam. Dry afterwards with a hair dryer. On small spots, one application is sufficient. Only treat surfaces where colour change is needed! If high opacity is desired, apply the colour in several layers and dry in-between layers with a hair dryer. The colour can be prepared according to our colour chart or send us a leather sample by post and we will mix it for you (an additional charge will apply for mixing colour according to a sample).

To maintain the top surface, we recommend our COLOURLOCK Leather Protector. It contains antioxidants, that stop the leather's decay, and UV filters to protect the surfaces from colour fading. It will also make the leather soft and supple once again. Use COLOURLOCK Leather Protector 24 hours after the colour refreshment. Apply with a soft cloth and let dry without polishing afterwards. One application is sufficient. Strained surfaces (heavy use or in sunlit areas) should be treated every three months. Clean before in case of soiling!